Sony have just released the firmware required to use the new 32Gb SxS-1 cards, the Memory Stick and SD Card adapters. This firmware also adds the ability to have much longer clip titles (46 Characters!) on the PMW-350 and EX1R. You can do the update yourself, you don’t have to send the camera back to Sony (hooray) to do the update. CLICK HERE to go to the firmware on the Sony UK site. Initial reports indicate that the update improves the performance of 3rd party SD card adapters and is straight forward to install. There are also indications that original EX3?s boot up a bit faster. At the moment the EX1 update appears to be missing from the download page, but I have been assured this will be rectified in the next 24 hours.
Tag Archives: PMW-EX1
Setting BOTH zebras on an XDCAM EX, very confusing!
If you set zebra 1 to 60 and then set zebra 2 to 90, then go back to zebra 1 you will find that the displayed value of zebra 1 will now be 90, however provided you don’t make any changes to zebra 1 if you go down to BOTH zebra 1 will work at 60 and zebra 2 at 90.
The thing is that going back to Zebra 1 (or zebra 2) and make any changes you select selects Zebra 1 (or 2) only, ie a single zebra and in doing so sets the level to the last level set. It’s only by going to BOTH that you enable both zebras together.
So to set two indendent zebras first set zebra 1 to your required level, then set zebra 2 to your required level, final scroll down to both and select. Now you zebras will be working at the independent levels you set, even though this may not appear to be the case in the menu.
It’s not the most logical way to lay out the menu as it does not show you both settings together at any point, hence the understandable confusion, but you will find that both zebras will work at the independent levels you set.